The PX-160 comes with the square SP-3 damper (sustain) pedal. It does the job but is far from an authentic piano experience. There are other piano-style pedals available, such as the M-Audio SP-2, that are nicer to play and don’t slide around as much. Casio offers the optional SP-33 pedal unit, which has a three-pedal configuration with separate soft, sostenuto, and sustain pedals—the traditional three-pedal setup found on most pianos. In duet play mode, the left and right pedals serve as damper pedals for their respective sides of the keyboard. The downside of the SP-33 is that it can be used only with Casio’s CS-67 stand (the two are also available together as a package).
A fully electronic kit is also easier to soundcheck than acoustic drums, assuming that the electronic drum module has levels that the drummer has pre-set in her/his practice room; in contrast, when an acoustic kit is sound checked, most drums and cymbals need to be miked and each mic needs to be tested by the drummer so its level and tone equalization can be adjusted by the sound engineer. As well, even after all the individual drum and cymbal mics are soundchecked, the engineer needs to listen to the drummer play a standard groove, to check that the balance between the kit instruments is right. Finally, the engineer needs to set up the monitor mix for the drummer, which the drummer uses to hear her/his instruments and the instruments and vocals of the rest of the band. With a fully electronic kit, many of these steps could be eliminated.
Traditional digital pianos vaguely resemble an electronic organ or a spinet harpsichord but usually lacking a fully enclosed lower section, while some models are based on the casework of traditional upright pianos with a fully enclosed bottom part and pedals that look like actual piano pedals. An opposite and recent trend is to produce an instrument which has a unique and distinctive appearance, unobtainable with a conventional instrument. Yamaha , Kawai and Casio makes a model which is designed to stand against a wall and is far shallower from keyboard to back than any possible upright design, as well as shorter height.
The keyboards all came in to our Los Angeles office. After unboxing them and setting them up, I invited Liz, Jack, and Brent to come in and try them out. I asked them to rate the key action and the sound of the piano and to evaluate features from the perspective of a beginner. After playing through all of them over a couple hours, we talked through the pros and cons of each keyboard, and they gave me their top three choices.
In some styles or settings, such as country music clubs or churches, small venues, or when a live recording is being made, the drummer may use a transparent perspex or plexiglas drum screen (also known as a drum shield) to dampen the onstage volume of the drums. A screen that completely surrounds the drum kit is known as a drum booth. In live sound applications, drum shields are used so that the audio engineer can have more control over the volume of drums that the audience hears through the PA system mix or to reduce the overall volume of the drums, as a way to reduce the overall volume of the band in the venue. In some recording studios, foam and fabric baffles are used in addition to or in place of clear panels. The drawback with foam/cloth baffle panels is that the drummer cannot see other performers, the record producer or the audio engineer well.
Trigger pads and drums, on the other hand, when deployed in a conventional set-up, are most commonly used to produce sounds not possible with an acoustic kit, or at least not with what is available. Any sound that can be sampled/recorded can be played when the pad is struck, by assigning the recorded sounds to specific triggers . Recordings or samples of barking dogs, sirens, breaking glass and stereo recordings of aircraft taking off and landing have all been used. Along with the more obvious electronically generated sounds there are synthesized human voices or song parts or even movie audio or digital video/pictures that (depending on device used) can also be played/triggered by electronic drums.
Although these kits may be small with respect to the number of drums used, the drums themselves are most often normal sizes, or even larger in the case of the bass drum. Kits using smaller drums in both smaller and larger configurations are also produced for particular uses, such as boutique kits designed to reduce the visual impact that a large kit creates or due space constraints in coffeehouses, travelling kits to reduce luggage volume, and junior kits for very young players. Smaller drums also tend to be quieter, again suiting smaller venues, and many of these kits extend this with extra muffling which allows quiet or even silent practice in a hotel room or bedroom.
Jump up ^ "Warren 'Baby' Dodds". The Percussive Arts Society. Archived from the original on 27 September 2011. Retrieved 21 November 2011. Dodds' way of playing press rolls ultimately evolved into the standard jazz ride-cymbal pattern. Whereas many drummers would play very short press rolls on the backbeats, Dodds would start his rolls on the backbeats but extend each one to the following beat, providing a smoother time flow.
The hi-hat cymbals (nicknamed "hats") consist of two cymbals mounted facing each other on a metal pole with folding support legs that keep a hollow support cylinder standing up. Like the bass drum, the hi-hat has a foot pedal. The bottom cymbal is fixed in place. The top cymbal is mounted on a thin pole which is inserted into the hollow cymbal stand cylinder. The thin pole is connected to a foot pedal. When the foot pedal is pressed down, a mechanism causes the thin pole to move down, causing the cymbals to move together. When the foot is lifted off the pedal, the cymbals move apart, due to the pedal's spring-loaded mechanism. The hi-hats can be sounded by striking the cymbals with one or two sticks or just by opening and closing the cymbals with the footpedal, without striking the cymbals. The ability to create rhythms on the hi-hats with the foot alone enables drummers to use both sticks on other drums or cymbals. Different sounds can be created by striking "open hi-hats" (without the pedal depressed, which creates a noisy sound nicknamed "sloppy hats") or a crisp "closed hi-hats" sound (with the pedal pressed down). As well, the high hats can be played with a partially depressed pedal.
For young children, parents are often inclined to start with a keyboard because they can be the least expensive. To decide whether or not this course of action is right for a young student, it’s good to have a conversation with that student’s music teacher. Often, music teachers would prefer that a child starts with a digital piano because they are going to have the requisite number of weighted keys and fewer distracting options. When a child learns to play on a keyboard, they may have a harder time adjusting to a digital or traditional piano. Music teachers also have preferences for which digital pianos they think are going to offer the best balance of sound and cost, and their experience with a particular instrument can certainly be helpful as your child learns. For these reasons, it’s always best to talk to a child’s music teacher before making a purchase. If your child has expressed an interest in learning to play the keyboard specifically, less expensive keyboards with fewer features can be a good place to start.
The bass guitar is an electric instrument that performs in both lead and backing roles. They are commonly used across a huge variety of musical genres and are attractive for their versatility, sound, and design. Manufacturers such as Fender and Ibanez offer a variety of both modern and vintage bass guitars, and each has multiple models with their own characteristics.
The crash cymbals are usually the strongest accent markers within the kit, marking crescendos and climaxes, vocal entries, and major changes of mood/swells and effects. A crash cymbal is often accompanied by a strong kick on the bass drum pedal, both for musical effect and to support the stroke. It provides a fuller sound and is a commonly taught technique.
For musicians like us that play bass, we never seem to get the recognition we deserve! Without us serving up those intricate grooves or beefy low-end riffs, the sound of our bands just wouldn’t be the same! Here at Sam Ash, we want you to know that we truly appreciate you as a bass player no matter what level you’re at or what style or genre of music you play!
Portable digital pianos, for the sake of lower production cost, were often equipped with a less complex system for the weighted keys. As a result, the feel of the keys is usually much less realistic than other digital pianos. However, it still retain the emulated weight mechanism (lower keys are heavier than higher ones), though not as precise as more expensive pianos. However, certain models include synthetic ivory-like keys as opposed to standard plastic keys.
Something else that you might like to consider is taking a cue from the bassists who have inspired you. Music is an art in which there's no shame in having an idol, and with plenty of signature bass guitars available, you can gear yourself up to follow in legendary footsteps. Take the Fender Jaco Pastorius Fretless Jazz Bass Guitar, for instance. Meticulously modelled after Jaco's own instrument, it carries on his spirit with a fretless design that lets you really unleash your creativity on the stage.
A drum kit — also called a drum set, trap set (a term using a contraction of the word, “contraption”), or simply drums — is a collection of drums and other percussion instruments, typically cymbals, which are set up on stands to be played by a single player, with drumsticks held in both hands, and the feet operating pedals that control the hi-hat cymbal and the beater for the bass drum. A drum kit consists of a mix of drums (categorized classically as membranophones, Hornbostel-Sachs high-level classification 2) and idiophones – most significantly cymbals, but can also include the woodblock and cowbell (classified as Hornbostel-Sachs high-level classification 1). In the 2000s, some kits also include electronic instruments (Hornbostel-Sachs classification 53). Also, both hybrid (mixing acoustic instruments and electronic drums) and entirely electronic kits are used.
In the 1950s, Leo Fender, with the help of his employee George Fullerton, developed the first mass-produced electric bass guitar. Fender was the founder of Fender Electric Instrument Manufacturing Company, which made popular brands of electric guitars, basses and amplifiers. Fender's Fender Precision Bass, which began production in October 1951, became a widely copied industry standard for the instrument. The Precision Bass (or "P-bass") evolved from a simple, un-contoured "slab" body design and a single coil pickup similar to that of a Telecaster, to a contoured body design with beveled edges for comfort and a split single coil pickup.
If our top pick isn’t available or you’re looking to save $50, the Yamaha P-45 is an excellent alternative. It was the favorite of one panelist, and the other three each ranked it second. It plays as well as our top pick, although I found the key weight to be a bit heavy for my tastes; it took a little more finger effort to play. Jack liked that heavier feel but could see it causing problems for beginners. Brent thought the action was about as good as it gets in this price range, and Liz thought it was easy to play.
In the mid-1970s, Alembic and other boutique bass manufacturers, such as Tobias, produced four-string and five-string basses with a low "B" string. In 1975, bassist Anthony Jackson commissioned luthier Carl Thompson to build a six-string bass tuned (low to high) B0, E1, A1, D2, G2, C3. In comparison with a standard four-string bass, Jackson's six-string adds a low B string and a high C string. These 5 and 6-string "extended-range basses" would become popular with session bassists as they reduced the need for re-tuning to alternate detuned configurations like "drop D", and also allowed the bassist to play more notes from the same position on the fretboard with fewer shifts up and down the fingerboard, a crucial benefit for a session player sightreading basslines at a recording session.
Several colleges offer electric bass training in the US. The Bass Institute of Technology (BIT) in Los Angeles was founded in 1978, as part of the Musician's Institute. Chuck Rainey (electric bassist for Aretha Franklin and Marvin Gaye) was BIT's first director. BIT was one of the earliest professional training program for electric bassists. The program teaches a range of modern styles, including funk, rock, jazz, Latin, and R&B.
However, with the technological advances, recent digital pianos are mostly capable of recreating string resonances, reverberations and other acoustical effects via digital signal processing (DSP) and modeling technology. One example is the Casio Privia, which is able to generate such acoustical effects by means of a simple DSP, which is far less complex than physical modeling.