In contrast to the upright bass (also called "double bass"), the electric bass guitar is played horizontally across the body, like an electric guitar. When the strings are plucked with the fingers (pizzicato), the index and middle fingers (and sometimes the thumb, ring, and little fingers as well) are used. James Jamerson, an influential bassist from the Motown era, played intricate bass lines using only his index finger, which he called "The Hook." There are also variations in how a bassist chooses to rest the right-hand thumb (or left thumb in the case of left-handed players). A player may rest his or her thumb on the top edge of one of the pickups or on the side of the fretboard, which is especially common among bassists who have an upright bass influence. Some bassists anchor their thumbs on the lowest string and move it off the lowest string when they need to play on the low string. Alternatively, the thumb can be rested loosely on the strings to mute the unused strings.
Drummers use a variety of accessories when practicing. Metronomes and beat counters are used to develop a sense of a steady pulse. Drum muffling pads may be used to lessen the volume of drums during practicing. A practice pad, held on the lap, on a leg, or mounted on a stand, is used for near-silent practice with drumsticks. A set of practice pads mounted to simulate an entire drum kit is known as a practice kit. In the 2010s, these have largely been superseded by electronic drums, which can be listened to with headphones for quiet practice and kits with non-sounding mesh heads.
Piezoelectric pickups (also called "piezo" pickups) are non-magnetic pickups that use a transducer to convert vibrations in the instrument's body or bridge into an electrical signal. They are typically mounted under the bridge saddle or near the bridge and produce a different tone from magnetic pickups, often similar to that of an acoustic bass. Piezo pickups are often used in acoustic bass guitars to allow for amplification without a microphone.
Some drummers arrive at the venue with their drum kit and use the mics and mic stands provided by the venue's sound engineer. Other drummers bring their all of their own mics, or selected mics (e.g., a good quality bass drum mic and a good mic for the snare) to ensure that they have good quality mics for each show. In bars and nightclubs, the microphones supplied by the venue can sometimes be in substandard condition, due to the heavy use they experience.
What started as a simple string and pedal sales catalog has grown exponentially over the past thirty years. The early days were a time where catalogs didn't have much of a presence in the industry, but what began as a college dorm room operation grew rapidly. In 1986 we moved to a full product offering and 64-page catalog, which over the years has grown to 162 pages. Join the AMS family and get your free catalog now!
Digital pianos typically use analog sensors for its keyboard action, as opposed to digital sensors of a regular keyboard and synthesizer. These sensors notably works in a similar way to those used in analog joysticks found on video game controllers, in which they the velocity input is converted from the key movement as well, not just the initial pressure of the key sensor.
Drum HeadsEvans Black DrumheadSee More Drum HeadsDrum SticksVic Firth American Classic 5A DrumsticksSee More Drum SticksDrum CasesSKB Drum CasesSee More Drum CasesDrum SilencersHQ Percussion Sound Off Drum Mute PackageSee More Drum SilencersDrum BagsProtection Racket Drum BagsSee More Drum BagsPractice PadsDrum Workshop Go Anywhere Practice Pad SetSee More Practice PadsSee All Drum Accessories
The placement of the pickup greatly affects the sound, timbre and tone of the instrument. A pickup near the neck joint emphasizes the fundamental and low-order harmonics and thus produces a deeper, bassier sound, while a pickup near the bridge emphasizes higher-order harmonics and makes a "tighter" or "sharper" sound. Usually basses with multiple pickups allow blending of the output from the pickups, with electrical and acoustical interactions between the two pickups (such as partial phase cancellations) allowing a range of tonal and timbral effects.
Other design options include finishes, such as lacquer, wax and oil; flat and carved designs; luthier-produced custom-designed instruments; headless basses, which have tuning machines in the bridge of the instrument (e.g., Steinberger and Hohner designs) and several artificial materials such as luthite. The use of artificial materials (e.g., BassLab) allows for unique production techniques such as die-casting, to produce complex body shapes. While most basses have solid bodies, they can also include hollow chambers to increase the resonance or reduce the weight of the instrument. Some basses are built with entirely hollow bodies, which change the tone and resonance of the instrument. Acoustic bass guitars have a hollow wooden body constructed similarly to an acoustic guitar, and are typically equipped with piezoelectric or magnetic pickups and amplified.
Electronic drums are used for many reasons. Some drummers use electronic drums for playing in small venues such as coffeehouses or church services, where a very low volume for the band is desired. Since fully electronic drums do not create any acoustic sound (apart from the quiet sound of the stick hitting the sensor pads), all of the drum sounds come from a keyboard amplifier or PA system; as such, the volume of electronic drums can be much lower than an acoustic kit. Some drummers use electronic drums as practice instruments, because they can be listened to with headphones, enabling a drummer to practice in an apartment or in the middle of the night without disturbing others. Some drummers use electronic drums to take advantage of the huge range of sounds that modern drum modules can produce, which range from sampled sounds of real drums, cymbals and percussion instruments (including instruments that would be impractical to take to a small gig, such as gongs or tubular bells), to electronic and synthesized sounds, including non-instrument sounds such as ocean waves.
Other kits will normally have 12" and 13" hanging toms plus either a 14" hanging tom on a stand, a 14" floor tom, or a 16" floor tom. For depths, see Tom-tom drum#Modern tom-toms. In the 2010s, it is very popular to have 10" and 12" hanging toms, with a 16" floor tom. This configuration is often called a hybrid setup. The bass drum is most commonly 22" in diameter, but rock kits may use 24", fusion 20", jazz 18", and in larger bands up to 26". A second crash cymbal is common, typically an inch or two larger or smaller than the 16", with the larger of the two to the right for a right-handed drummer, but a big band may use crashes up to 20" and ride up to 24" or, very rarely, 26". A rock kit may also substitute a larger ride cymbal or larger hi-hats, typically 22" for the ride and 15" for the hats.
Most electric bass guitars use magnetic pickups. The vibrations of the instrument's ferrous metal strings within the magnetic field of the permanent magnets in magnetic pickups produce small variations in the magnetic flux threading the coils of the pickups. This in turn produces small electrical voltages in the coils. Many bass players connect the signal from the bass guitar's pickups to a bass amplifier and loudspeaker using a 1/4" patch cord. These low-level signals are then strengthened by the bass amp's preamplifier electronic circuits, and then amplified with the bass amp's power amplifier and played through one or more speaker(s) in a cabinet.
Most five-piece kits, at more than entry level, also have one or more effects cymbals. Adding cymbals beyond the basic ride, hi-hats and one crash configuration requires more stands in addition to the standard drum hardware packs. Because of this, many higher-cost kits for professionals are sold with little or even no hardware, to allow the drummer to choose the stands and also the bass drum pedal he/she prefers. At the other extreme, many inexpensive, entry-level kits are sold as a five-piece kit complete with two cymbal stands, most often one straight and one boom, and some even with a standard cymbal pack, a stool and a pair of 5A drum sticks. In the 2010s, digital kits are often offered in a five-piece kit, usually with one plastic crash cymbal triggers and one ride cymbal trigger. Fully electronic drums do not produce any acoustic sound beyond the quiet tapping of sticks on the plastic or rubber heads. The trigger-pads are wired up to a synth module or sampler.
The electric bass is a relative newcomer to the world of jazz. The big bands of the 1930s and 1940s Swing era and the small combos of the 1950s Bebop and Hard Bop movements all used the double bass. The electric bass was introduced in some bands in the 1950s and it became prominent during the late 1960s and early 1970s, when rock influences were blended with jazz to create jazz-rock fusion.
In addition to the keyboard by itself, there are different bundles available on Amazon. A Beginners Bundle includes the CS-67 stand, SP-33 pedal board, CB7 bench, and a polish cloth. The Essentials Bundle comes with a padded bench, X-stand (not a double-X like we recommend), and a pair of headphones. It’s nice that the bundles are there, but I’d suggest buying things separately to make sure you get what you need and nothing unnecessary.
If a second hanging tom is used, it is 10" diameter and 8" deep for fusion, or 13" diameter and one inch deeper than the 12" diameter tom. Otherwise, a 14" diameter hanging tom is added to the 12", both being 8" deep. In any case, both toms are most often mounted on the bass drum with the smaller of the two next to the hi-hats (on the left for a right-handed drummer). These kits are particularly useful for smaller venues where space is limited, such as coffeehouses and small pubs.
The sound of electronic drums and cymbals themselves is heard by the drummer and possibly other musicians in close proximity, but even so, the foldback (audio monitor) system is usually fed from the electronic sounds rather than the live acoustic sounds. The drums can be heavily dampened (made to resonate less or subdue the sound), and their tuning and even quality is less critical in the latter scenario. In this way, much of the atmosphere of the live performance is retained in a large venue, but without some of the problems associated with purely microphone-amplified drums. Triggers and sensors can also be used in conjunction with conventional or built-in microphones. If some components of a kit prove more difficult to "mike" than others (e.g., an excessively "boomy" low tom), triggers may be used on only the more difficult instruments, balancing out a drummer's/band's sound in the mix.
Copyright © 1996-2018 American Musical Supply, Inc. All rights reserved. American Musical Supply reserves the right to correct pricing and/or product specifications in the event of typographical errors found in our print catalog or on our website. If a product is listed at an incorrect price due to such errors or because of inaccurate information received from a supplier, American Musical Supply shall have the right to refuse or cancel any orders placed, whether or not the order has been confirmed and your credit card charged. If your credit card has already been charged for the purchase and your order is canceled, American Musical Supply will issue a credit to your credit card account in the amount of the charge.