The slap and pop method, or "thumbstyle", most associated with funk, uses tones and percussive sounds achieved by striking, thumping, or "slapping" a string with the thumb and snapping (or "popping") a string or strings with the index or middle fingers. Bassists often interpolate left hand-muted "ghost notes" between the slaps and pops to achieve a rapid percussive effect, and after a note is slapped or popped, the fretting hand may cause other notes to sound by using "hammer-ons", "pull-offs", or a left-hand glissando (slide). Larry Graham of Sly and the Family Stone and Graham Central Station was an early innovator of the slap style, and Louis Johnson of The Brothers Johnson is also credited as an early slap bass player.
In 1919, US Congress passed a prohibition law outlawing the manufacturing and transporting of drinking alcohol. When drinking became illegal, it became popular in underground nightclubs. The type of music that was played at these underground establishments that were selling alcohol was jazz. It was not seen as upstanding to listen to or perform jazz music, because it was an African American style and at that time the United States was segregated and racism was an overtly prevalent issue. Because jazz music was seen as great dance music, big band jazz became popular in nightclubs. In the 1920s, freelance drummers emerged. They were hired to play shows, concerts, theaters, clubs and back dancers and artists of various genres. Just as modern drummers have many different roles, so did the drummers of the 1920s. One important role for drummers in the 1920s is what is referred to in modern times as a foley artist. During silent films, an orchestra was hired to accompany the silent film and the drummer was responsible for providing all the sound effects. Drummers played instruments to imitate gun shots, planes flying overhead, a train coming into a train station, and galloping horses etc.
The effects, on the other hand, are great, and there are a lot of them: eight different reverbs, eight choruses, and three modulation effects (tremolo, vibrato, or rotary speaker). The keyboard stores your effect settings for each of the 12 sounds in memory, so they’ll be restored when you choose that sound again or turn the keyboard off. These are likely to be less important and useful for a beginner than basic sounds, though effects might appeal to those looking for an inexpensive performance piano.
When you hear a person humming music, what is it that you hear? Commonly, it's the bass line. Something about those low, rhythmic notes really have a big impact, with some of the best examples being "Seven Nation Army" by the White Stripes and "Under Pressure" by Queen. There are countless others you could surely name, but the bottom line is that the bass guitar is a crucial part of modern music and definitely an instrument to be proud of. Fortunately, with dozens of bass guitars for sale here, you're sure to find one that strikes the right chord with you.
Many basses have just one pickup, typically a "P" or "MM" pickup, though single soapbars are not unheard of. Multiple pickups are also quite common, two of the most common configurations being two "J" pickups (as on the stock Fender Jazz), or a "P" near the neck and a "J" near the bridge (e.g., Fender Precision Bass Special, Fender Precision Bass Plus). A two-"soapbar" configuration is also very common, especially on basses by makes such as Ibanez and Yamaha. A combination of a J or other single-coil pickup at the neck and a Music Man-style humbucker in the bridge has become popular among boutique instrument builders, giving a very bright, focused tone that is good for jazz, funk and thumbstyle.
Bassists often play a bass line composed by an arranger, songwriter or composer of a song—or, in the case of a cover song, the bass line from the original. In other bands—e.g., jazz-rock bands that play from lead sheets and country bands using the Nashville number system—bassists are expected to improvise or prepare their own part to fit the song's chord progression and rhythmic style.
There are many varieties of picks available, but due to the thicker, heavier strings of the electric bass, bassists tend to use heavier picks than those used for electric guitar, typically ranging from 1.14 mm–3.00 mm (3.00 is unusual). Different materials are used for picks, including plastic, nylon, rubber, and felt, all of which produce different tones. Felt and rubber picks sound closer to a fingerstyle tone.
No matter how you choose to distinguish yourself - acoustic-electric, custom, signature model, extended range or the tried-and-true standbys - one thing that will never change is that music is a personal thing. Only you can decide which bass guitar belongs onstage and in the studio with you, so you've got every reason to check out all the instruments here: chances are you'll know the right one when you find it.
It's a fact that standard drum sets and cymbals are only scratching the surface of what percussion can do. In this section, it's easy to see just how deep your potential is as a drummer with plenty of the usual suspects as well as a ton of more exotic instruments and accessories. If you're ready to bring the rhythms and beats to the stage, you've got thousands of ways right here to make it happen.
One of the main things to consider when looking at a 4-string bass (and every bass for that matter) is the material used to make its body. Bass guitars are traditionally made of different varieties of wood and feature a solid, hard-bodied design. Alder is a favorite amongst musicians because it produces a clear, full-bodied sound. For warmer, smoother tones, a mahogany bass might be the one for you. Another aspect to look into is a fretted or fretless electric bass guitar. On a fretted bass, the frets divide the fingerboard into semi tone divisions. These models make learning the bass easier because you have a guide for finger placement. Fretless basses offer a different sound because without frets the strings are directly pressed into the wood of the neck. This produces a softer sound because the string is in direct contact with the musician's finger and also allows you to slide up and down the neck with ease. The electric bass guitar is said to be the cornerstone of the band. It establishes the beat and brings a booming, punchy sound to the music. From Flea of the Red Hot Chili Peppers to Paul McCartney of the Beatles, musicians have been playing the bass for decades in modern, mainstream music groups. No matter what skill level you're at right now, these is certainly an electric bass guitar that will meet and exceed all your sound and style needs.
If you really want to distinguish yourself as a bassist, it can pay to think outside the box and go for something a bit less traditional. For example, there are musical styles and occasions where an electric bass may be slightly out of place. In those cases, you can turn to an acoustic-electric bass. These have a classic sound all their own, and if you're headed to a festival or singing around a campfire, they'll do the job even without an amplifier handy.
Tapewound (double bass type) and flatwound strings are sometimes used with the fretless bass so the metal string windings do not wear down the fingerboard. Tapewound and flatwound strings have a distinctive tone and sound. Some fretless basses have epoxy-coated fingerboards, or fingerboards made of an epoxy composite like micarta, to increase the fingerboard's durability, enhance sustain, and give a brighter tone.
In some cases, to play the bass through PA amplification, it is plugged into a direct box or DI, which routes the signal to the bass amp while also sending the signal directly into a mixing console, and thence to the main and monitor speakers. When a recording of bass is being made, engineers may use a microphone set up in front of the amplifier's speaker cabinet for the amplified signal, a direct box signal that feeds the recording console, or a mix of both.
A fully electronic kit is also easier to soundcheck than acoustic drums, assuming that the electronic drum module has levels that the drummer has pre-set in her/his practice room; in contrast, when an acoustic kit is sound checked, most drums and cymbals need to be miked and each mic needs to be tested by the drummer so its level and tone equalization can be adjusted by the sound engineer. As well, even after all the individual drum and cymbal mics are soundchecked, the engineer needs to listen to the drummer play a standard groove, to check that the balance between the kit instruments is right. Finally, the engineer needs to set up the monitor mix for the drummer, which the drummer uses to hear her/his instruments and the instruments and vocals of the rest of the band. With a fully electronic kit, many of these steps could be eliminated.
But maybe you're looking for a kit that is truly special, one that will make jaws drop with its looks and ears perk up with its sounds. If that's what you have in mind, then you're really going to adore the DW Collector's Series Satin Specialty 5-Piece Shell Pack. This customizable kit is part of DW's flagship line, representing a pinnacle of performance power. This kit features maple shells that offer a great low-end punch and is absolutely loaded with massive tones and unparalleled versatility. Without a doubt, this kit makes the statement that you've arrived as a drummer. When you're pounding out the beat, you want it to sound great. That's why you should trust your sound to one of the great kits available here. Whether you're a first time drummer, or a legendary rocker headed on another world tour, we've got you covered.
Maple/Mahogany 13x7 snare drum White Glass Finish with Black Nickel Hardware. The shell features North American Hard Rock Maple and African Mahogany construction, combined with VLT (Vertical Low Timbre) shell technology. THIS Drum is AMAZING!!!! Extremly versatile in great condition. Bid with confidence and please check my other auctions. snare only stand not included.
A four-piece kit extends the three-piece by adding one tom, either a second hanging tom mounted on the bass drum (a notable user is Chris Frantz of Talking Heads) and often displacing the cymbal, or by adding a floor tom. Normally another cymbal is added as well, so there are separate ride and crash cymbals, either on two stands, or the ride cymbal mounted on the bass drum to the player's right and the crash cymbal on a separate stand. The standard cymbal sizes are 16" crash and 18"–20" ride, with the 20" ride most common.
Picking from the huge variety of bass guitars available in the market can be a daunting task for any beginning bass guitar player. There are many factors that you need to take into account first, before making your first purchase. It is important that you spend some time to look at every factor carefully so you will be happy with the guitar you buy.
Electronic drum pads are the second most widely used type of MIDI performance controllers, after electronic music keyboards.:319–320 Drum controllers may be built into drum machines, they may be standalone control surfaces (e.g., rubber drum pads), or they may emulate the look and feel of acoustic percussion instruments. The pads built into drum machines are typically too small and fragile to be played with sticks, and they are usually played with fingers.:88 Dedicated drum pads such as the Roland Octapad or the DrumKAT are playable with the hands or with sticks, and are often built to resemble the general form of a drum kit. There are also percussion controllers such as the vibraphone-style MalletKAT,:88–91 and Don Buchla's Marimba Lumina.
The first thing you need to look for when buying your bass guitar is the number of strings it has. A bass guitar can come with four, five, or six strings. The four string bass is the one that you may see most often and it is the easiest one for beginners to learn. The five or six string bass is for players who like to play around with different musical styles or perform a lot of solos. For a beginning bass player, I would recommend that you may start with the four string bass.
Jump up ^ Tunings such as B–E–A–D (this requires a low "B" string in addition to the other three "standard" strings, and omits the G string), D–A–D–G (a "standard" set of strings, with only the lowest string detuned from E down to D), and D–G–C–F or C–G–C–F (a "standard" set of strings, all of which are detuned either a whole tone, or a whole tone for the three higher-pitched strings and two tones for the E, which is dropped to a low C) give bassists an extended lower range. A tenor bass tuning of A–D–G–C, in which the low E is omitted and a high C is added, provides a higher range.
There's a lot to be said for tradition when it comes to the bass guitar, and it's a tradition that ultimately goes back to the originals: the Jazz Bass and Precision Bass. With some stellar options available from Fender and Squier, you're in a good place to get started with those iconic bass guitars. On the other hand, if you'd prefer something a bit more unique, you've got no shortage of options. Over the years, the bass guitar market has grown hugely, and there are now a ton of choices ranging from beginner-friendly instruments like Rogue and Dean models all the way to professional masterpieces from luthiers such as Warwick, Schecter and Rickenbacker.
Traditional digital pianos vaguely resemble an electronic organ or a spinet harpsichord but usually lacking a fully enclosed lower section, while some models are based on the casework of traditional upright pianos with a fully enclosed bottom part and pedals that look like actual piano pedals. An opposite and recent trend is to produce an instrument which has a unique and distinctive appearance, unobtainable with a conventional instrument. Yamaha , Kawai and Casio makes a model which is designed to stand against a wall and is far shallower from keyboard to back than any possible upright design, as well as shorter height.