Palm-muting is a widely used bass technique. The outer edge of the palm of the picking hand is rested on the bridge while picking, and "mutes" the strings, shortening the sustain time. The harder the palm presses, or the more string area that is contacted by the palm, the shorter the string's sustain. The sustain of the picked note can be varied for each note or phrase. The shorter sustain of a muted note on an electric bass can be used to imitate the shorter sustain and character of an upright bass. Palm-muting is commonly done while using a pick, but can also be done without a pick, as when doing down-strokes with the thumb.
The fretless comes with smooth wood as you would get on an upright bass or violin. Though many assume this may be the best to use, but the sound quality entirely depends on your finger position. This is why the skilled players depend on the memory of their muscles for perfect positioning of their hands. Nevertheless, the more you practice, the better you’ll get.
Prior to the development of the drum set, drums and cymbals used in military and orchestral music settings were played separately by different percussionists; if the score called for bass drum, triangle and cymbals, three percussionists would be hired to play these three instruments. In the 1840s, percussionists began to experiment with foot pedals as a way to enable them to play more than one instrument, but these devices would not be mass-produced for another 75 years. By the 1860s, percussionists started combining multiple drums into a set. The bass drum, snare drum, cymbals, and other percussion instruments were all struck with hand-held drum sticks. Drummers in musical theater shows and stage shows, where the budget for pit orchestras was often limited, contributed to the creation of the drum set by developing techniques and devices that would enable them to cover the roles of multiple percussionists.
Like the Casio, the Yamaha has a duet mode that allows two people to play in the same register at the same time. However, the P-45 has only one headphone output, so you’ll need a splitter for both players to use headphones while playing together. The headphone jack is located on the back panel of the keyboard, making access a bit more difficult than with the Casio’s front-mounted jacks. The console controls are minimal, and while Jack liked the simplicity, Brent and I found them unintuitive.
Maybe you're looking for something a bit more conspicuous, that you can make into the centerpiece of your music room? If so, you'll want to investigate options like the Yamaha Arius YDP-142 and Suzuki Micro Grand Digital Piano. These advanced instruments sound every bit as gorgeous as they look, and they offer the ability to record your and store your performances to listen again later or even to playback as accompaniments.
Optical pickups are another type of non-magnetic pickup. They use an infrared LED to optically track the movement of the string, similar to the mechanism of modern computer mice, which allows them to reproduce low-frequency tones at high volumes without the "hum" or excessive resonance associated with conventional magnetic pickups. Since optical pickups do not pick up high frequencies or percussive sounds well, they are commonly paired with piezoelectric pickups to fill in the missing frequencies. LightWave Systems builds basses with optical pickups.
Drummers using electronic drums, drum machines, or hybrid acoustic-electric kits (which blend traditional acoustic drums and cymbals with electronic pads) typically use a monitor speaker, keyboard amplifier or even a small PA system to hear the electronic drum sounds. Even a drummer playing entirely acoustic drums may use a monitor speaker to hear her drums, especially if she is playing in a loud rock or metal band, where there is substantial onstage volume from huge, powerful guitar stacks. Since the drum kit uses the deep bass drum, drummers are often given a large speaker cabinet with a 15" subwoofer to help them monitor their bass drum sound (along with a full-range monitor speaker to hear the rest of their kit). Some sound engineers and drummers prefer to use an electronic vibration system, colloquially known as a "butt shaker" or "throne thumper" to monitor the bass drum, because this lowers the stage volume. With a "butt shaker", the "thump" of each bass drum strike causes a vibration in the drum stool; this way the drummer feels their beat on the posterior, rather than hears it.
Most basses have a volume potentiometer ("pot" or "knob"), which can be turned up or down, and a tone potentiometer, which rolls off the high frequencies when it is turned to the player's right. Some basses may also have a pickup selector control or switch, to select single-coil or humbucking pickups. Since the 1980s, basses are often available with battery-powered "active" electronics that boost the signal with a preamplifier and provide equalization controls to boost or cut bass and treble frequencies, or both. Some expensive basses have even more equalization options, such as bass, middle and treble.
Some bassists use other types of tuning to extend the range or get other benefits, such as providing multiple octaves of notes at any given position, or a larger tonal range. Instrument types or tunings used for this purpose include basses with fewer than four strings (one-string bass guitars, two-string bass guitars, three-string bass guitars [tuned to E–A–D]) and alternative tunings (e.g., tenor bass).
Several colleges offer electric bass training in the US. The Bass Institute of Technology (BIT) in Los Angeles was founded in 1978, as part of the Musician's Institute. Chuck Rainey (electric bassist for Aretha Franklin and Marvin Gaye) was BIT's first director. BIT was one of the earliest professional training program for electric bassists. The program teaches a range of modern styles, including funk, rock, jazz, Latin, and R&B.
Drums with cylindrical shells can be open at one end (as is the case with timbales), or can have two drum heads, one head on each end. Single-headed drums typically consist of a skin stretched over an enclosed space, or over one of the ends of a hollow vessel. Drums with two heads covering both ends of a cylindrical shell often have a small hole somewhat halfway between the two heads; the shell forms a resonating chamber for the resulting sound. Exceptions include the African slit drum, also known as a log drum as it is made from a hollowed-out tree trunk, and the Caribbean steel drum, made from a metal barrel. Drums with two heads can also have a set of wires, called snares, held across the bottom head, top head, or both heads, hence the name snare drum. On some drums with two heads, a hole or bass reflex port may be cut or installed onto one head, as with some 2010s era bass drums in rock music.