An LCD readout and a few more buttons on the control panel would go a long way toward making the keyboard’s options easier to use. The metronome function especially could be more user friendly. It has 10 speed presets, labeled 0-9, with a + and – for adjustment. These are selectable with the Function button and a key press. While practicing and deciding on tempo, most students find it more beneficial to know the exact BPM (beats per minute), which is impossible here using the built-in metronome.
Like the electric guitar, the electric bass guitar is almost always connected to an amplifier and a speaker with a patch cord for live performances. Electric bassists use either a "combo" amplifier, which combines an amplifier and a speaker in a single cabinet, or an amplifier and one or more speaker cabinets (typically stacked, with the amplifier sitting on the speaker cabinets, leading to the term "half-stack" for one cabinet setups and "full stack" for two).
A fully electronic kit is also easier to soundcheck than acoustic drums, assuming that the electronic drum module has levels that the drummer has pre-set in her/his practice room; in contrast, when an acoustic kit is sound checked, most drums and cymbals need to be miked and each mic needs to be tested by the drummer so its level and tone equalization can be adjusted by the sound engineer. As well, even after all the individual drum and cymbal mics are soundchecked, the engineer needs to listen to the drummer play a standard groove, to check that the balance between the kit instruments is right. Finally, the engineer needs to set up the monitor mix for the drummer, which the drummer uses to hear her/his instruments and the instruments and vocals of the rest of the band. With a fully electronic kit, many of these steps could be eliminated.
In a jazz setting, the electric bass tends to have a much more expansive solo role than in most popular styles. In most rock settings, the bass guitarist may only have a few short bass breaks or brief solos during a concert. During a jazz concert, a jazz bassist may have a number of lengthy improvised solos, which are called "blowing" in jazz parlance. Whether a jazz bassist is comping (accompanying) or soloing, they usually aim to create a rhythmic drive and "timefeel" that creates a sense of "swing" and "groove". For information on notable jazz bassists, see the List of jazz bassists article.
Although we might take some flak from guitarists, we bassists know the truth: a band just wouldn't be the same without the deep, rumbling tones of the bass laying the foundation for everyone else. Any instrument can play a memorable tune, but it's up to the bass guitar to really put in the heartbeat and soul that separates a great song from an average one. Naturally, giving a great performance is all about being in touch with your instrument, and for that, you'll want to take a careful look at the basses here to find the one that fits you best.
Although these kits may be small with respect to the number of drums used, the drums themselves are most often normal sizes, or even larger in the case of the bass drum. Kits using smaller drums in both smaller and larger configurations are also produced for particular uses, such as boutique kits designed to reduce the visual impact that a large kit creates or due space constraints in coffeehouses, travelling kits to reduce luggage volume, and junior kits for very young players. Smaller drums also tend to be quieter, again suiting smaller venues, and many of these kits extend this with extra muffling which allows quiet or even silent practice in a hotel room or bedroom.
Strumming, usually with finger nails, is a common technique on acoustic guitar, but it is not a commonly used technique for bass. However, notable examples are Stanley Clarke's bass playing on the introduction to "School Days", on the album of the same name, and Lemmy who was noted for his use of chords, often playing the bass like a rhythm guitar.
The string can be plucked (or picked) at any point between the bridge and the point where the fretting hand is holding down the string on the fingerboard; different timbres (tones) are produced depending on where along the string it is plucked. When plucked closer to the bridge, the string's harmonics are more pronounced, giving a brighter tone. Closer to the middle of the string, these harmonics are less pronounced, giving a more mellow, darker tone.