The bare minimum requirements for a budget digital piano are to have 88 keys (the same number found on traditional acoustic pianos) and internal speakers to facilitate practicing without an amplifier. Beyond that, some amount of weighted key action (either semi-weighted or hammer action, more on this in a moment) and an accurate piano sound were the primary deciding factors for our picks. An included stand and sustain pedal were not requirements, as aftermarket options are readily available and inexpensive. (We discuss some options below.)
Torzal Natural Twist is a bass guitar body and neck style invented by luthier Jerome Little from Amherst, Massachusetts. It consists of a neck rotated by a total of 35 degrees, with (+)15 degrees at the bridge and (-)20 at the nut. The designer claims that the ergonomic design increases efficiency of the hands, wrists and arms, which reduces the risk of developing repetitive strain injuries like carpal tunnel syndrome or tendonitis. This design is also beneficial to players who have already suffered from such injuries. This patented design differs from traditional bass guitar design by twisting the neck, and bringing the strings toward a more natural hand position at either end of the instrument. The rotation at either side of the instrument in the direction of the hand creates a neck plane that models the natural motion of the hand as it reaches outward. The fretboard also forms a straight line at the location of each string, which should improve the ease of performance.
A fully electronic kit is also easier to soundcheck than acoustic drums, assuming that the electronic drum module has levels that the drummer has pre-set in her/his practice room; in contrast, when an acoustic kit is sound checked, most drums and cymbals need to be miked and each mic needs to be tested by the drummer so its level and tone equalization can be adjusted by the sound engineer. As well, even after all the individual drum and cymbal mics are soundchecked, the engineer needs to listen to the drummer play a standard groove, to check that the balance between the kit instruments is right. Finally, the engineer needs to set up the monitor mix for the drummer, which the drummer uses to hear her/his instruments and the instruments and vocals of the rest of the band. With a fully electronic kit, many of these steps could be eliminated.
As with any instrument, the perfect digital piano for you is going to be based on one part function and two parts preference. It doesn't matter if you're a beginner or a master pianist: the first step to your new digital piano is simply to decide which one suits you best. With that accomplished, you're well on your way to making the next step in your career with a brand new instrument you can truly call your own
Jump up ^ "Warren 'Baby' Dodds". The Percussive Arts Society. Archived from the original on 27 September 2011. Retrieved 21 November 2011. Dodds' way of playing press rolls ultimately evolved into the standard jazz ride-cymbal pattern. Whereas many drummers would play very short press rolls on the backbeats, Dodds would start his rolls on the backbeats but extend each one to the following beat, providing a smoother time flow.
Eight and twelve-string models are both built on the same "course string" concept found on twelve-string guitars, where sets of strings are spaced together in groups of two or three that are primarily played simultaneously. These instruments typically have one of the strings in each course tuned an octave above the 'standard' string, although a fifth above is also used. Instruments with ten and fifteen strings, grouped in five courses, also exist, as do "extended-range basses" or ERBs with non-coursed string counts rivaling those of coursed-string basses.
Six strings are usually tuned B0–E1–A1–D2–G2–C3—like a four-string bass with an additional low B string and a high C string. Some players prefer B0–E1–A1–D2–F♯2–B2, which preserves the intervals of standard six-string guitar tuning (an octave and a fourth lower) and makes the highest and lowest string the same note two octaves apart. While less common than four or five-string basses, they appear in Latin, jazz, and other genres, as well as in studio work where a session musician's single instrument must be highly versatile, and to facilitate sightreading in the recording studio. Alternative tunings for six-string bass include B–E–A–D–G–B, matching the first five strings of an acoustic or electric guitar with an additional low B, and E–A–D–G–B–E, completely matching the tuning of a six-string guitar but one octave lower allowing the use of guitar chord fingerings. Rarer tunings such as E–A–D–G–C–F and F♯–B–E–A–D–G provide a lower or higher range in a given position while maintaining consistent string intervals. In 1974, Anthony Jackson worked with Carl Thompson to create the Contrabass guitar (BEADGC). Later, Jackson brought his ideas to Fodera and worked with Ken Smith to create a wider-spaced Contrabass guitar, which evolved to the modern six-string bass.
CajonsLatin Percussion LP1428NY Black Box CajonSee More CajonsMisc. PercussionRemo Key-Tuned FiberSkyn DjembeSee More Misc. PercussionChildren's Drums and PercussionRemo Kids PercussionSee More Children's Drums and PercussionCongasToca Synergy Conga SetSee More CongasBongosLatin Percussion BongosSee More BongosTambourinesRemo Fiberskyn 3 Pretuned Head TambourineSee More TambourinesSnare DrumsTama SLP G Bubinga Snare DrumSee More Snare DrumsSee All Other Drums and Percussion
In "miking" a drum kit, dynamic microphones, which can handle high sound-pressure levels, are usually used to close-mic drums, which is the predominant way to mic drums for live shows. Condenser microphones are used for overheads and room mics, an approach which is more common with sound recording applications. Close miking of drums may be done using stands or by mounting the microphones on the rims of the drums, or even using microphones built into the drum itself, which eliminates the need for stands for these microphones, reducing both clutter and set-up time, as well as isolating them.