On early recording media (until 1925) such as wax cylinders and discs carved with an engraving needle, sound balancing meant that musicians had to be literally moved in the room. Drums were often put far from the horn (part of the mechanical transducer) to reduce sound distortion. Since this affected the rendition of cymbals at playback, sound engineers of the time remedied the situation by asking drummers to play the content of the cymbals onto woodblocks, temple blocks, and cowbells for their loudness and short decay.
Microphones ("mics") are used with drums to pick up the sound of the drums and cymbals for a sound recording and/or to pick up the sound of the drum kit so that it can be amplified through a PA system or sound reinforcement system. While most drummers use microphones and amplification in live shows in the 2010s, so that the sound engineer can adjust and balance the levels of the drums and cymbals, some bands that play in quieter genres of music and that play in small venues such as coffeehouses play acoustically, without mics or PA amplification. Small jazz groups such as jazz quartets or organ trios that are playing in a small bar will often just use acoustic drums. Of course if the same small jazz groups play on the mainstage of a big jazz festival, the drums will be mic'ed so that they can be adjusted in the sound system mix. A middle-ground approach is used by some bands that play in small venues; they do not mic every drum and cymbal, but rather mic only the instruments that the sound engineer wants to be able to control in the mix, such as the bass drum and the snare.
Electronic drum pads are the second most widely used type of MIDI performance controllers, after electronic music keyboards.:319–320 Drum controllers may be built into drum machines, they may be standalone control surfaces (e.g., rubber drum pads), or they may emulate the look and feel of acoustic percussion instruments. The pads built into drum machines are typically too small and fragile to be played with sticks, and they are usually played with fingers.:88 Dedicated drum pads such as the Roland Octapad or the DrumKAT are playable with the hands or with sticks, and are often built to resemble the general form of a drum kit. There are also percussion controllers such as the vibraphone-style MalletKAT,:88–91 and Don Buchla's Marimba Lumina.
Cascio Interstate Music offers a huge selection of Drum & Percussion Gear - for the Beginner to the Professional Musician. We carry more than 20,000 Acoustic Drumsets & Electronic Drums, Cymbals, Latin Instruments, World Percussion, Ethnic Drums, Hardware, Drumsticks, Heads & Drummer accessories. We have the Largest Drum Catalog in the Country! Buy Drums & Accesories with Confidence at interstatemusic.com - Including DW, Pearl, Mapex, LP, Gretsch, Meinl, Paiste, Zildjian, Vic Firth, Remo, Roland & more! Don't forget to check out our Drum Outlet, New Products & Musical Instrument Rebates. Gift Cards, plastic or electronic, offer a choice for the musician in your life.
This guitar has got a maple C-shape neck with a 9.5-inch radius and 20 medium jumbo frets. Most bass playing occurs in the lower fret positions that make 20 frets ideal for bass playing. The single coil feature is quite simple to use and it will create both a bright and focused sound quality. If you are looking for a bass guitar that plays on a small scale, this is just the right one for you.
The fretting hand can add vibrato to a plucked or picked note, either a gentle, narrow vibrato or a more exaggerated, wide vibrato with bigger pitch variations. For fretted basses, vibrato is always an alternation between the pitch of the note and a slightly higher pitch. For fretless basses, the player can use this style of vibrato, or they can alternate between the note and a slightly lower pitch, as is done with the double bass and on other unfretted stringed instruments. While vibrato is mostly done on "stopped" notes—that is, notes that are pressed down on the fingerboard—open strings can also be vibratoed by pressing down on the string behind the nut. As well, the fretting hand can be used to "bend" a plucked or picked note up in pitch, by pushing or pulling the string so that the note sounds at a higher pitch. To create the opposite effect, a "bend down", the string is pushed to a higher pitch before being plucked or picked and then allowed to fall to the lower, regular pitch after it is sounded. Though rare, some bassists may use a tremolo bar-equipped bass to produce the same effect.